In SiteVision v 2.00, you can place a "default" calibration file in a folder on Connect, and that calibration file will be applied to all model data in that folder. Prior to SiteVision version 2.00, to associate a calibration file with a model file the file names of the model and the calibration file had to be the same this meant that a calibration file needed to be created for each model file. This file must be renamed to match your model name and stored in the Trimble Connect folder with your model. Battalion).I want to proof their work before I proceed. I add the grid point from a list points Ive imported into the current job, that were supplied by a third party (USACE Eng.
NOTE – For georeferencing models that do not have a supported co-ordinate system, a JXL file with the Selected:0 data will create a Georeferenced file with just the necessary projection and geoid model information. In the site calibration menu of the TSC2, the software is asking me for a 'GNSS point name', right below where I specify a 'Grid point name'. If there are control points in the model, they do not need to be selected for inclusion in the jobXML (JXL) file. NOTE – You do not have to have any points in the model.